You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
What steps will reproduce the problem?
1. start in verbose mode and pick any mac...
The software is displaying which channels it is hopping but always skips the
first channel.
Thanks and regards,
Boris
Original issue reported on code.google.com by Boris.W...@gmail.com on 31 Dec 2011 at 12:50
The text was updated successfully, but these errors were encountered:
Reaver starts at channel 2 and loops through channels until it sees a beacon.
If no beacon is found, it will continue cycling through channels, including
channel 1. For example, if you provide Reaver with a fake BSSID, you'll see it
cycling through channels in this order:
2
3
4
5
6
7
8
9
10
11
12
13
14
1
2
3
4
...
Once a beacon from the target BSSID is seen, Reaver will switch to whatever
channel the AP reports in the beacon packet.
Original comment by cheff...@tacnetsol.com on 31 Dec 2011 at 1:04
Original issue reported on code.google.com by
Boris.W...@gmail.com
on 31 Dec 2011 at 12:50The text was updated successfully, but these errors were encountered: