…ating around out there).
…s the startup time and pulls the mosfet pins low immediately to prevent floating pins from potentially overheating the mosfet on reset or startup.
…d heater seem to work wonderfully.
casting from all over. Added delay on hard reset to avoid getting a dreaded debug blinky because the extruder didn't come up fast enough. Closes gh-36.
Some extruder and motherboard fixups in response to stress tests Key code is the atomic-lock in ExtruderMotor.cc. I'll be blunt: I don't understand what sequence of interruptions could cause that code block to make anything fail. The only way to get any deeper would be to disassemble, and the current task list doesn't make that likely atm. no disassemble!
only manifests on 1.3 so haven't tested
…rmware to build with the Arduino IDE. Changed a #if statement in Extruder.cpp concerning valve commands and HeatedPlatform (there was a ! missing)
…try to build it.