The latest version (V1.6) problem still exists

[ChengHero]

The latest version (V1.6) problem still exists, my hardware is canable, similar to the problem of killisch, it has not been repaired after flashing V1.6, and there is a problem with the cycle sending, and the cycle is unstable. Sorry for my bad english.

[ChengHero]

Regarding the issue of periodic sending, it should be my wrong operation, sorry

[moonglow]

Hi @ChengHero !

You have such issue on new 4.3.0 drivers and if you install previous version of drivers ( from that thread: LINK ) all is OK ? Because i have no problem with new drivers for now, maybe i need to do more testing.

[ChengHero]

hi @moonglow
thank you ！！maybe my problem，I will try it on version 4.3.0

[moonglow]

Hm.. can you provide me more info:

• PCAN driver version
• Operating System

thank you

[ChengHero]

Reinstalling 4.3.0 doesn't work either，My hardware is not orthodox, the soc is STM32F072, I don't know if it will affect。I think it should be my hardware problem。Operating System is windows 10。

[ChengHero]

My canable hardware is personally designed with reference to the canable hardware on github

[moonglow]

So your adapter is connected to bus and work only few second ? correct ?

[ChengHero]

Worked for a split second before, not for a few seconds

[moonglow]

Your adapter is connected to active CAN bus ?

[ChengHero]

I tested it with PEAK-PCAN and it is OK

[moonglow]

So now all is OK ?

[ChengHero]

It still doesn't work, but it's ok to use genuine hardware

[moonglow]

Ah... OK, thank you. Please try old drivers as temporary solution.

[ChengHero]

thank you！！

[ChengHero]

hi ... @moonglow ，I tried to downgrade the driver version to 3.4.0.9248, the problem was solved, thank you

[moonglow]

I did try to upload canable precompiled firmware from my release page and it works fine with latest 4.3.0.16563 drivers under Windows 10 x64 with PCAN View and BusMaster. I test over few hours and it works just fine.

[ChengHero]

I think so too, the device is working very well, there are only some occasional problems after that, thank you

[P208PUG]

I did try to upload canable precompiled firmware from my release page and it works fine with latest 4.3.0.16563 drivers under Windows 10 x64 with PCAN View and BusMaster. I test over few hours and it works just fine.

is possible to get a precompiled bin(pcan) for candlelight hw