Permalink
Fetching contributors…
Cannot retrieve contributors at this time
93 lines (65 sloc) 3.09 KB

Raspberry Pi

Mopidy runs on all versions of Raspberry Pi. However, note that the Raspberry Pi 2 and 3 are significantly more powerful than the Raspberry Pi 1 and Raspberry Pi Zero; Mopidy will run noticably faster on the later models.

raspberrypi2.jpg

How to for Raspbian

  1. Download the latest Raspbian Desktop or Lite disk image from http://www.raspberrypi.org/downloads/raspbian/.

    Unless you need a full graphical desktop the Lite image is preferable since it's much smaller.

  2. Flash the Raspbian image you downloaded to your SD card.

    See the Raspberry Pi installation docs for instructions.

    You'll need to enable SSH if you are not connecting a monitor and a keyboard. As of the November 2016 release, Raspbian has the SSH server disabled by default. SSH can be enabled by placing a file named 'ssh', without any extension, onto the boot partition of the SD card. See here for more details.

  3. If you boot with only a network cable connected, you'll have to find the IP address of the Pi yourself, e.g. by looking in the client list on your router/DHCP server. When you have found the Pi's IP address, you can SSH to the IP address and login with the user pi and password raspberry. Once logged in, run sudo raspi-config to start the config tool as the root user.

  4. Use the raspi-config tool to setup the basics of your Pi. You might want to do one or more of the following:

    • Change the password of the pi user.
    • Change the language, time zone, etc.

    Under "Advanced Options":

    • Set a hostname.
    • Enable SSH if not already enabled.
    • Force a specific audio output. By default, when using a HDMI display the audio will also be output over HDMI, otherwise the 3.5mm jack will be used.
    • Adjust the memory split. If you're not using a display (i.e. Raspbian Lite), you should set the minimum value here in order to make best use of the available RAM.

    Once done, select "Finish". Depending on what you changed you may be asked if you want to restart your Pi, select "Yes" and then log back in again afterwards.

    If you want to change any settings later, you can simply rerun sudo raspi-config.

  5. Install Mopidy and any Mopidy extensions you want, as described in :ref:`debian-install`.

Note

If you used the Raspbian Desktop image you may also need to add the mopidy user to the video group. Run sudo adduser mopidy video to do this.

Testing sound output

You can test sound output independent of Mopidy by running:

aplay /usr/share/sounds/alsa/Front_Center.wav

If you hear a voice saying "Front Center", then your sound is working.

If you want to change your audio output setting, simply rerun sudo raspi-config.