Permalink
Fetching contributors…
Cannot retrieve contributors at this time
executable file 230 lines (211 sloc) 8.16 KB
<?xml version="1.0" encoding="utf-8"?>
<glgps xmlns="http://www.glpals.com/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.glpals.com/ glconfig.xsd" >
<!--HAL Confguration -->
<hal
acPortName="/dev/s3c2410_serial1" lBaudRate="115200" cLogEnabled="false" acLogDirectory="/data/gps/log/" ltoFileName="lto2.dat"
enhanced-assisted="false" cp-enhanced-assisted="false" TISEnabled="false" RILEnabled="true" LPmode="false" cp-cold-start="false" cp-guard-time-sec="2"
arp-supl-enable="true" arp-supl-cap-msb="true" arp-supl-cap-msa="true" arp-supl-cap-ecid="false" arp-supl-reaiding-time-sec="1200"
acSuplServer="supl.google.com" SuplPort="7276"
LbsEnable="true" LbsLocal="false" LbsServer="bcmls2.glpals.com" LbsPort="7275" LbsSyncTimeSec = "60" LbsSyncLto="true" LbsSyncCells="true"
LbsGetGpsAssistance="false"
LbsSyncLtoThresholdDays="3"
gpioNStdbyPath="/sys/class/sec/gps/GPS_PWR_EN/value"
gpioNResetPath="/sys/class/sec/gps/GPS_nRST/value"
gpioDelayMs="250"
lcsApiSockName="/dev/socket/gps"
acNvStoDir="/data/gps/"
/>
<!-- Parameters passed to GlEngine -->
<!--gll
LogPriMask="LOG_DEBUG"
LogFacMask="LOG_GLLAPI | LOG_DEVIA | LOG_NMEA | LOG_RAWDATA | LOG_DEVMS | LOG_ASIC_IO | LOG_BBTEST | LOG_DEVET | LOG_MESM | LOG_DEVKF | LOG_DEVJG | LOG_DEVMR"
FrqPlan="FRQ_PLAN_10MHZ_2PPM_10MHZ_100PPB" FrqPlan="FRQ_PLAN_10MHZ_2PPM" "FRQ_PLAN_16_8MHZ_2PPM"
RfType="GL_RF_PALS7" "GL_RF_BARRACUDA" "GL_RF_2075_LN22" "GL_RF_2075_BRCM" "GL_RF_PALS7_BRCM" "GL_RF_BARRACUDA_BRCM" "GL_RF_BARRACUDA_EXT_LNA"
NOTE: "GL_RF_BARRACUDA_EXT_LNA" should be used for BAS
LbsEnable="true" LbsLocal="true" LbsServer="bcmlbsqa1.glpals.com" LbsPort="7275" LbsSyncTimeSec = "60" LbsSyncLto="true" LbsSyncCells="true"
/-->
<!-- NOTE: BrcmRFwildBase, BrcmRFclkDiv, anBrcmRFclkRefHz only needed for Broadcom RF front end test chips
( i.e. GL_RF_2075_BRCM and GL_RF_PALS7_BRCM ) -->
<gll
LogPriMask="LOG_DEBUG"
LogFacMask="LOG_GLLAPI | LOG_NMEA | LOG_ASIC_IO"
FrqPlan="FRQ_PLAN_26MHZ_2PPM_26MHZ_300PPB"
RfType="GL_RF_4751_DANUBE_EXT_LNA"
pps-enable="false" pps-offset-ms="0" pps-width-ns="100"
WarmStandbyTimeout1Seconds="5"
WarmStandbyTimeout2Seconds="10"
CNoSmoothEnable="true"
>
<periodic_hor_acc_remap>
<remap in="50" out="55" />
</periodic_hor_acc_remap>
</gll>
<!-- List of jobs can be performed by the GPS controller -->
<!-- The default job all parameters are set to default values -->
<!-- Periodic Position Fix using default settings -->
<job id="Periodic">
<task>
<req_pos/>
</task>
</job>
<!-- Periodic Position with the ROM almanac ignored for simulator testing -->
<job id="Simulator_Periodic">
<task id="cont" repeat="1">
<startup ignore_rom_alm="true" />
<req_pos validfix="2000" duration_sec="4500"/>
</task>
</job>
<!-- Repetetive cold starts -->
<job id="Cold_Starts">
<task repeat="1000000">
<startup
ignore_osc="false"
ignore_rom_alm="false"
ignore_ram_alm="false"
ignore_pos="true"
ignore_nav="true"
ignore_time="true"
/>
<req_pos validfix="1"/>
</task>
</job>
<!-- Repetetive cold starts with the ROM almanac ignored for simulator testing -->
<job id="Simulator_Cold_Starts">
<task repeat="1000000">
<startup
ignore_osc="false"
ignore_rom_alm="true"
ignore_ram_alm="false"
ignore_pos="true"
ignore_nav="true"
ignore_time="true"
/>
<req_pos validfix="1"/>
</task>
</job>
<!-- Repetetive warm starts
Stored ephemeris data is discarded before the start begins
This simulates GPS receiver start after it was left off for more that 4 hours
-->
<job id="Warm_Starts">
<task repeat="1000000">
<startup ignore_nav="true"/>
<req_pos validfix="1"/>
</task>
</job>
<!-- Repetetive warm starts performed on GPS simulator -->
<job id="Simulator_Warm_Starts">
<task repeat="1000000">
<startup
ignore_rom_alm="true"
ignore_nav="true"
/>
<req_pos validfix="1"/>
</task>
</job>
<!-- Repetetive hot starts -->
<job id="Hot_Starts">
<task repeat="1000000">
<req_pos validfix="1"/>
</task>
</job>
<!-- This job must be performed every time the GPS simulator scenarion is reset -->
<job id="CollectEphemeris">
<task repeat="1">
<startup
ignore_osc="true"
ignore_rom_alm="true"
ignore_ram_alm="true"
ignore_pos="true"
ignore_nav="true"
ignore_time="true"
/>
<req_pos validfix="200"/>
</task>
</job>
<!-- This job performes series of single shot requests using the data stored
in NVRAM to simulate assistance data received from the network
The QoS parameters are set to maxmize the GPS sensitivity
-->
<job id="Assisted_Cold_Starts">
<task repeat="1000000">
<startup
ignore_rom_alm="true"
ignore_ram_alm="true"
/>
<asst>
<!--pos Lat="-30.0" Lon="-50.0" Alt="50" /-->
<pos Lat="33.7691" Lon="-84.4062" Alt="300" />
<!--pos Lat="37.0" Lon="-122.0" Alt="50" /-->
<!--pos Lat="37.26533652" Lon="-121.94128855" Alt="51.4" /-->
</asst>
<req_pos_single acc="50" timeout="30" />
</task>
</job>
<!-- This job performes series of single shot requests using the data stored
in NVRAM to simulate assistance data received from the network
The QoS parameters are set as it woudld be set by Spirent ULTS executing
3GPP TS performance tests.
-->
<job id="3GPP_Assisted_Cold_Starts">
<task repeat="1000000">
<startup
ignore_rom_alm="true"
ignore_ram_alm="true"
/>
<asst>
<!--pos Lat="-30.0" Lon="-50.0" Alt="50" /-->
<pos Lat="33.7691" Lon="-84.4062" Alt="300" />
<!--pos Lat="37.0" Lon="-122.0" Alt="50" /-->
<!--pos Lat="37.26533652" Lon="-121.94128855" Alt="51.4" /-->
</asst>
<req_pos_single acc="25" timeout="20" />
</task>
</job>
<!-- This job starts signle chanel factory test mode
The signal is expected to be in the range from -125 dBm to -145 dBm
with the frequency offset range from -2 ppm to +2 ppm
for this mode to provide reliable results
-->
<job id="Factory_High_SNR">
<task id="test" repeat="1">
<startup
ignore_osc="true"
ignore_rom_alm="true"
ignore_ram_alm="true"
ignore_pos="true"
ignore_nav="true"
ignore_time="true"
/>
<req_ftest
PRN="1"
GL_FACT_TEST_MODE="GL_FACT_TEST_CONT"
GL_FACT_TEST_ITEMS="GL_FACT_TEST_WER"
avg_int_sec="10"
duration_sec="60"
/>
</task>
</job>
<!-- This job is intended to be ran after the Factory_High_SNR job
It uses the TCXO offset stored in NVRAM during the Factory_High_SNR job
-->
<job id="Factory_Low_SNR">
<task id="test" repeat="1">
<startup
ignore_osc="false"
ignore_rom_alm="true"
ignore_ram_alm="true"
ignore_pos="true"
ignore_nav="true"
ignore_time="true"
/>
<req_ftest
PRN="1"
GL_FACT_TEST_MODE="GL_FACT_TEST_CONT"
GL_FACT_TEST_ITEMS="GL_FACT_TEST_WER"
avg_int_sec="10"
duration_sec="200"
/>
</task>
</job>
</glgps>