Skip to content
Permalink
Branch: develop
Commits on Apr 6, 2019
Commits on Apr 4, 2019
  1. Fix inverted logic for SA1/GSU RAM writes. 🤦‍♂️

    mrehkopf committed Apr 4, 2019
    This broke SA1+SuperFX in 1.10.2...
  2. Explicitly set pair mode data directions when setting game video mode

    mrehkopf committed Apr 4, 2019
    In case pair mode wasn't successfully detected/engaged before
  3. move pair mode detection outside of reset (to enable Super Nt operation)

    mrehkopf committed Apr 4, 2019
    Still needs some work because Super Nt has a very long initial boot
    delay (about 4 seconds) but it works after a warm boot at least...
  4. separate status into fields governed by MCU and by SNES

    mrehkopf committed Apr 4, 2019
    Avoid status getting overwritten by race conditions
  5. correct PINMODE assignment for CIC data lines

    mrehkopf committed Apr 4, 2019
    This doesn't fix anything because the lines' modes are always switched
    both at a time. But the assignment was still vice versa.
Commits on Apr 3, 2019
Commits on Mar 29, 2019
Commits on Mar 28, 2019
  1. update changelog

    mrehkopf committed Mar 28, 2019
Commits on Mar 26, 2019
  1. update changelog for v1.10.2

    mrehkopf committed Mar 26, 2019
  2. formatting

    mrehkopf committed Mar 26, 2019
  3. S-DD1: avoid memory corruption on SRAM writes

    mrehkopf committed Mar 26, 2019
    Fixes saving not working in Star Ocean on some occasions
  4. update comments

    mrehkopf committed Mar 26, 2019
  5. Avoid memory corruption on MCU writes

    mrehkopf committed Mar 26, 2019
    (address invalid before end of write strobe)
Commits on Mar 8, 2019
Commits on Mar 1, 2019
  1. update changelog

    mrehkopf committed Mar 1, 2019
  2. Actually use the MENU_FILENAME placeholder everywhere m(

    mrehkopf committed Mar 1, 2019
    Fixes boot on Mk.III
Commits on Feb 28, 2019
  1. Add ChipScope debugging to main core

    mrehkopf committed Feb 28, 2019
    Can be enabled/disabled in config.vh, due to Spartan 3 space constraints
    some block RAMs have to be disabled in order to use it...
  2. S-DD1 support by Magno

    mrehkopf committed Feb 28, 2019
  3. Print loading message on boot if FPGA is already configured

    mrehkopf committed Feb 28, 2019
    (Otherwise don't waste time configuring it just for the message)
Older
You can’t perform that action at this time.