From eae5e55a7938504691f8be27665c6fa3935a01d9 Mon Sep 17 00:00:00 2001 From: Sander Vanheule Date: Fri, 26 Nov 2021 22:16:47 +0100 Subject: [PATCH] realtek: remove hardcoded sys-led configurations setup.c unconditionally sets the sys-led mode (blinking rate) to a permanent high output. This may cause issues when a board expects this pin to toggle periodically, e.g. when hooked up to an external watchdog. If the sys-led peripheral is used to control an LED, the mux should be configured to use the pin as GPIO0, allowing for better control as a GPIO LED. Signed-off-by: Sander Vanheule --- .../files-5.10/arch/mips/rtl838x/setup.c | 40 ------------------- 1 file changed, 40 deletions(-) diff --git a/target/linux/realtek/files-5.10/arch/mips/rtl838x/setup.c b/target/linux/realtek/files-5.10/arch/mips/rtl838x/setup.c index 18c477eb0fe729..e0adbf87e99f1f 100644 --- a/target/linux/realtek/files-5.10/arch/mips/rtl838x/setup.c +++ b/target/linux/realtek/files-5.10/arch/mips/rtl838x/setup.c @@ -28,31 +28,6 @@ extern struct rtl83xx_soc_info soc_info; -static void __init rtl838x_setup(void) -{ - /* Setup System LED. Bit 15 then allows to toggle it */ - sw_w32_mask(0, 3 << 16, RTL838X_LED_GLB_CTRL); -} - -static void __init rtl839x_setup(void) -{ - /* Setup System LED. Bit 14 of RTL839X_LED_GLB_CTRL then allows to toggle it */ - sw_w32_mask(0, 3 << 15, RTL839X_LED_GLB_CTRL); -} - -static void __init rtl930x_setup(void) -{ - if (soc_info.id == 0x9302) - sw_w32_mask(0, 3 << 13, RTL9302_LED_GLB_CTRL); - else - sw_w32_mask(0, 3 << 13, RTL930X_LED_GLB_CTRL); -} - -static void __init rtl931x_setup(void) -{ - sw_w32_mask(0, 3 << 12, RTL931X_LED_GLB_CTRL); -} - void __init plat_mem_setup(void) { void *dtb; @@ -71,21 +46,6 @@ void __init plat_mem_setup(void) * parsed resulting in our memory appearing */ __dt_setup_arch(dtb); - - switch (soc_info.family) { - case RTL8380_FAMILY_ID: - rtl838x_setup(); - break; - case RTL8390_FAMILY_ID: - rtl839x_setup(); - break; - case RTL9300_FAMILY_ID: - rtl930x_setup(); - break; - case RTL9310_FAMILY_ID: - rtl931x_setup(); - break; - } } void __init plat_time_init(void)