- First release KickStarter rewards May-Nov 2015
Nov 15 onwards
- Pull back tracks and GND place around mount holes
- Connect OOK to GPIO 18
- Move OOK to top of board to avoid Pi2 connector shorting issue
- Disconnect RJ45 pin 1 and 3 from GND to stop short when Ethernet is inserted * Add to silkscreen that the diode Cathode (flat line - negative) points upward) on the PCB and the Anode goes to GND (downward) * Add double side silkscreen for LCD I2C & switch header * Fix 'designed by' typo on rear silkscreen :-)