Installing the Arduino IDE – Windows 10
by Robert Wall
Arduino themselves have a wealth of information on installing the IDE on most operating systems in the 'Get Started' part of their website. Be sure to read through this before continuing.
Download the latest Arduino IDE (use your favourite search engine on “Arduino IDE”) and click on
This will download a file with a name like “arduino-1.8.3-windows.exe” (the name will change depending on the version) to your usual location. Double-click on that file and allow it to install in the normal way. Part way through the installation, it will ask for the components to install. For our purposes, you do not need to install the USB driver, you will later need to install the Silicon Labs drivers.
When the installation finishes, the progress bar will show “Completed”.
Download and Install the SiLabs FTDI Drivers
If you are using the cable sold through the OpenEnergyMonitor shop, do not follow the instructions for installing the drivers on the Arduino website, instead download the drivers from https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx.
Download VCP ...
This will download a zip file
CP210x_Windows_Drivers.zip to your usual location. Extract the
contents to a convenient place and you will find two installers, one for 32-bit computers
CP210xVCPInstaller_x86.exe) and one for 64-bit (
on the correct one for your machine and allow it to install the drivers in the normal way.
Make sure you restart the Arduino IDE after installing the drivers. Before you connect the
Tools > Port [or
Serial Port]. If
Port is greyed out, that's OK, if not and any
COM (serial) ports are listed, make a note of which they are. Now connect the programmer and
your module (emonTx, emonTH, etc). Go back to the main menu and select
Tools again. [Serial]
Port should be available and showing a new port. Select that port. Under
Tools > Board ensure
Arduino/Genuino Uno is selected.
If you have a favourite text editor, you can use it instead of the built-in editor. Select
File > Preferences
and tick the box
Use external editor. When you use an external editor, your workflow
is slightly different. You must still open the sketch in the IDE, but the IDE does not open your editor -
you must yourself open the sketch file in your external editor, and save the file when editing is
done. Then you switch to the IDE where you can click
Upload and the IDE will read
the file again and then proceed to compile it (“Verify”) or compile and upload it (“Upload”).
Read the section on Installing the Libraries before you set your Sketchbook location (under