Skip to content
MewPro for Hero 4 Black/Silver
Other C++ C
Branch: master
Clone or download
Fetching latest commit…
Cannot retrieve the latest commit at this time.
Permalink
Type Name Latest commit message Commit time
Failed to load latest commit information.
Comparison.md
LED.cpp
LICENSE
MewPro.h
MewPro4.ino
Pins.h
README.md
WireS.cpp
WireS.h
a_Queue.ino
b_Parser.ino
c_I2C.ino
d_TimeAlarms.ino
e_Shutter.ino
startup.h

README.md

#MewPro4

Arduino BacPac™ for GoPro Hero 4 Black/Silver: GoPro can be controlled by ATtiny1634 attached on Herobus.

Resources:


###Prerequisites

In order to use MewPro 2 as a Hero 4 Black/Silver controller you need the following hardwares:

Softwares:

MewPro 2 is shipped with optiboot as well as MewPro4 software for genlocking. But if you like to modify/update the software you will need to prepare the following IDE, core. To install each software please refer their documentations.

(A modified WireS library is distributed with MewPro 4 source code package, so you don't need to download the original version separately.)

Lastly grab the MewPro4 application:

  • MewPro4 Application
  • This is an open source software (MIT license). You can modify and distribute it as you like.

###Connections

On your PC launch Arduino IDE that was installed as described in the above. In Arduino IDE [File]→[Open...]→ then open MewPro4.ino.

Connect MewPro 2

!(http://mewpro.cc/wp-content/uploads/connection2.jpg)

to your PC with FTDI board and the temporary header.

!(http://mewpro.cc/wp-content/uploads/conne2.jpg)

Connecting FTDI please refer the pinout image below:

!(http://mewpro.cc/wp-content/uploads/MewPro2.jpg)

Then connect them to GoPro Hero 4 Black/Silver.

!(http://mewpro.cc/wp-content/uploads/conne1.jpg)

In Arduino IDE application, select [Tools]→[Board]→[ATTiny1634 (optiboot)] and [Tools]→[Port]→[(the port where you connected the FTDI cable)]. (B.O.D. and Clock settings are “don’t care” as these values are only effective when you burn a bootloader to the microcontroller by using an ISP programmer.)

MewPro4 source code is targeted to MewPro 2 board, genlocking with Iliad, and Hero 4 Black/Silver firmware version v3.0.0 or later (please note v4.0.0 and/or v5.0.0 has a fatal bug in bulk setting transfer). So the code should be complied successfully without any modifications. Click "Verify" the MewPro4 sketch and "Upload" it to MewPro 2 board.

You can’t perform that action at this time.