MDBT42Q code lost upon power cycle

[espruino-discuss]

Posted at 2019-02-11 by Drc3p0

I tried out the demo code on the individually addressable led page listed at http://www.espruino.com/Individually+Addressable+LEDs
The code worked great, but when I disconnect/reconnect power, the code does not run. I can upload the code again, but it doesn't appear to save the code when its power cycled. Is this normal behavior of the MDBT42Q?

Thanks for your help

[espruino-discuss]

Posted at 2019-02-11 by @allObjects

Did you enter save() in the console - left side in the IDE after upload?

[espruino-discuss]

Posted at 2019-02-11 by @allObjects

...one more thing:

make the last two lines of the your code like this (put the original last two lines into onInit() {...}; function in order to not save messed status.

onInit() {
  setWatch(changePattern, BTN, { repeat: true, edge:'falling' });
  setInterval(doLights,50);
}

With that change though, the code will not start on upload. This is annoying while you devleop... If you add this line as a very last line while you develop and when ready to save it, just comment this line before the upload.

setTimeout(onInit,500); // while dev'g - comment before upload for save()

I hope this helps.

PS: How do you get rid of saved code - prevent it from automatically starting?

When connected, inter in the console reset(1) . This will not only stop the code but also remove it from FLASH, so that a next time you power cycle, it is not there anymore to be run.

If you want stop a piece of code, you just say reset() without argument.

[gfwilliams]

Posted at 2019-02-11 by @gfwilliams

http://www.espruino.com/Saving will explain the whole save process in a bit more detail if you're interested