Apigility Skeleton Application
Via release tarball
tar xzf zf-apigility-skeleton-0.8.0.tgz
Via Composer (create-project)
You can use the
create-project command from Composer
to create the project in one go:
curl -s https://getcomposer.org/installer | php -- php composer.phar create-project -sdev zfcampus/zf-apigility-skeleton path/to/install
Via Git (clone)
First, clone the repository:
git clone https://github.com/zfcampus/zf-apigility-skeleton.git # optionally, specify the directory in which to clone cd path/to/install
At this point, you need to use Composer to install dependencies. Assuming you already have Composer:
Once you have the basic installation, you need to put it in development mode:
cd path/to/install php public/index.php development enable # put the skeleton in development mode
Now, fire it up! Do one of the following:
- Create a vhost in your web server that points the DocumentRoot to the
public/directory of the project
- Fire up the built-in web server in PHP (5.4.8+) (note: do not use this for production!)
In the latter case, do the following:
cd path/to/install php -S 0.0.0.0:8080 -t public public/index.php
You can then visit the site at http://localhost:8080/ - which will bring up a welcome page and the ability to visit the dashboard in order to create and inspect your APIs.
NOTE ABOUT USING THE PHP BUILT-IN WEB SERVER
PHP's built-in web server did not start supporting the
PATCH HTTP method until
5.4.8. Since the admin API makes use of this HTTP method, you must use a version
>= 5.4.8 when using the built-in web server.
NOTE ABOUT OPCACHE
Disable all opcode caches when running the admin!
The admin cannot and will not run correctly when an opcode cache, such as APC or OpCache, is enabled. Apigility does not use a database to store configuration; instead, it uses PHP configuration files. Opcode caches will cache these files on first load, leading to inconsistencies as you write to them, and will typically lead to a state where the admin API and code become unusable.
The admin is a development tool, and intended for use a development environment. As such, you should likely disable opcode caching, regardless.
When you are ready to deploy your API to production, however, you can disable development mode, thus disabling the admin interface, and safely run an opcode cache again. Doing so is recommended for production due to the tremendous performance benefits opcode caches provide.