@avtolstoy avtolstoy released this Dec 13, 2018 · 37 commits to mesh-develop since this release

Assets 38

0.8.0-rc.26

IMPORTANT

IMPORTANT: Argon NCP firmware needs to be updated to v0.0.5 after updating to 0.8.0-rc.26 from any release under 0.8.0-rc.25. The release binaries can be found here

BUGFIXES

  • [Argon] Escape special characters in SSIDs and passwords (#1604)
  • [Gen 3] Network system events are correctly generated (#1585)
  • [Gen 3] Correct C++ contructor array alignment in system-part1 (#1594)
  • [Gen 3] Fixed a conflict between DHCPv4-assigned and ND6-assigned DNS servers (#1596)
  • [Argon / Boron] Fixed a race condition when restarting the GSM07.10 multiplexer causing a memory leak/corruption (#1608)
  • [Gen 3] IPv4 IPAddress endianness issue fixed (#1610)
  • [Boron] Fixed a crash when using STARTUP() macro to manage Cellular credentials (#1613)
  • [Gen 3] Embedded user part update procedure fixed in for hybrid builds (#1617)
  • [communication] Sticky SKIP_SESSION_RESUME_HELLO no longer set immediately after session resume (#1623)
  • [Gen 3] OpenThread locking fixes (#1625)
  • [Gen 3] NetworkManager initiail state initialized in network_setup()
  • [Gen 3] IPv4 IPAddress endianness issue fixed (#1610)
  • [Gen 3] Fixes an assertion failure in LwIP DHCP code when receiving an offer with > 2 DNS servers (#1618)
  • [Argon / Xenon] Wire1 enabled (#1633)

ENHANCEMENTS

  • [Boron] 3G Borons no longer incur 10 second power-on delay when cold booting (#1584)
  • [Gen 3] Build time significantly improved (#1587)
  • [Gen 3] Hardware-accelerated SHA-1 (#1593)
  • [Gen 3] Newlib 3.0 compatibility (#1599)
  • [Argon / Boron] AT parser immediately interrupted when GSM07.10 multiplexer exits asynchronously (e.g. terminated by the peer or due to keepalive timeout) (#1608)
  • [Gen 3] NAT64 initial base source port randomized on boot (#1609)
  • [Gen 3] LwIP optimizations (#1610)
  • [Gen 3] DHCP hostname option enabled (defaults to DeviceID) (#1595)
  • [Argon] WiFi passwords are not included in the logging output (#1619)
  • [Gen 3] Power failure comparator always configured with 2.8V threshold (#1621)
  • [Gen 3] Default mesh transmit power setting changed from 0dBm to 8dBm (#1629)
  • [Gen 3] BLE MTU and data length changed to default minimum values, while still allowing upgrade by the peer up to the maximums available on nRF52840 (#1634)

FEATURES

  • [Gen 3] SPI slave mode (#1588)
  • [Gen 3] I2C slave mode (#1591)
  • [Gen 3] Servo HAL (#1589)
  • [Gen 3] Implement a control request to retrieve the module info in the protobuf format (#1614)

INTERNAL

  • [Gen 3] Run unit tests as part of a CI build (#1604).