Skip to content

HTTPS clone URL

Subversion checkout URL

You can clone with HTTPS or Subversion.

Download ZIP
Reprap FW with look ahead. SDcard and LCD support. It works on Gen6, Ultimaker, RAMPS and Sanguinololu
branch: Marlin_dev(not…

This branch is 2127 commits behind MarlinFirmware:Development

Fetching latest commit…

Cannot retrieve the latest commit at this time

Failed to load latest commit information.
Marlin
README
README.md

README.md

WARNING: THIS IN A PROCESS OF HEAVY OVERWORKING. DO NOT USE THIS ON YOUR MACHINE UNTIL FURTHER NOTICE!!!

This RepRap firmware is a mashup between Sprinter, grbl and many original parts.

Derived from Sprinter and Grbl by Erik van der Zalm. Sprinters lead developers are Kliment and caru. Grbls lead developer is Simen Svale Skogsrud. Some features have been added by and configuration has been added by: Bernhard Kubicek, Matthijs Keuper, Bradley Feldman, and others...

Features:

  • Interrupt based movement with real linear acceleration
  • High steprate
  • Look ahead (Keep the speed high when possible. High cornering speed)
  • Interrupt based temperature protection
  • preliminary support for Matthew Roberts advance algorithm For more info see: http://reprap.org/pipermail/reprap-dev/2011-May/003323.html
  • Full endstop support
  • Simple LCD support (16x2)
  • SD Card support
  • Provisions for Bernhard Kubicek's new hardware control console and 20x4 lcd

This firmware is optimized for Ultimaker's gen6 electronics (including the Ultimaker 1.5.x daughterboard and Arduino Mega 2560).

The default baudrate is 115200.

Configuring and compilation

Install the latest arduino software IDE/toolset (currently 0022) http://www.arduino.cc/en/Main/Software

Install Ultimaker's RepG 25 build http://software.ultimaker.com (or alternatively install Kliment's printrun/pronterface https://github.com/kliment/Printrun_)

Copy the Ultimaker Marlin firmware https:/github.com/bkubicek/Marlin (Use the download button)

Start the arduino IDE. Select Tools -> Board -> Arduino Mega 2560 Select the correct serial port in Tools ->Serial Port Open Marlin.pde

Click the Verify/Compile button

Click the Upload button If all goes well the firmware is uploading

Start Ultimaker's Custom RepG 25 Make sure Show Experimental Profiles is enabled in Preferences Select Sprinter as the Driver

Press the Connect button.

KNOWN ISSUES: RepG will display: Unknown: marlin x.y.z

That's ok. Enjoy Silky Smooth Printing.

Something went wrong with that request. Please try again.