Permalink
| # For more options and information see | |
| # http://www.raspberrypi.org/documentation/configuration/config-txt.md | |
| # Some settings may impact device functionality. See link above for details | |
| kernel=uboot.bin | |
| # uncomment if you get no picture on HDMI for a default "safe" mode | |
| #hdmi_safe=1 | |
| # uncomment this if your display has a black border of unused pixels visible | |
| # and your display can output without overscan | |
| #disable_overscan=1 | |
| # uncomment the following to adjust overscan. Use positive numbers if console | |
| # goes off screen, and negative if there is too much border | |
| #overscan_left=16 | |
| #overscan_right=16 | |
| #overscan_top=16 | |
| #overscan_bottom=16 | |
| # uncomment to force a console size. By default it will be display's size minus | |
| # overscan. | |
| #framebuffer_width=1280 | |
| #framebuffer_height=720 | |
| # uncomment if hdmi display is not detected and composite is being output | |
| #hdmi_force_hotplug=1 | |
| # uncomment to force a specific HDMI mode (this will force VGA) | |
| #hdmi_group=1 | |
| #hdmi_mode=1 | |
| # uncomment to force a HDMI mode rather than DVI. This can make audio work in | |
| # DMT (computer monitor) modes | |
| #hdmi_drive=2 | |
| # uncomment to increase signal to HDMI, if you have interference, blanking, or | |
| # no display | |
| #config_hdmi_boost=4 | |
| # uncomment for composite PAL | |
| #sdtv_mode=2 | |
| #uncomment to overclock the arm. 700 MHz is the default. | |
| #arm_freq=800 | |
| dtparam=i2c_arm=on | |
| dtparam=i2c_vc=on | |
| #i2s=on | |
| #spi=on | |
| dtparam=act_led_trigger=heartbeat | |
| dtparam=pwr_led_trigger=mmc0 | |
| device_tree_address=0x02000000 | |
| core_freq=250 |