• BEFORE YOU DO ANYTHING, READ THIS FIRST.
• Main Instructions
• Step 1: Get the necessary tools
• Step 2: Remove support material from 3D-printed parts
• Step 3: Solder ADNS-5050 sensor to printed circuit board
• Step 4: Remove the small kapton tab protecting the sensor
• Step 5: Place aluminum tape into base
• Step 6: Place printed circuit board into base
• Step 7: Place ADNS-5050 sensor optic into top
• Step 8: Place bottom onto top
• Step 9: Screw top into base
• Step 10: Prepare bearing press jig
• Step 11: Insert roller bearing and roller bearing dowel into bearing press jig
• Step 12: Press the bearing press jig together
• Step 13: Remove bearing from bearing press jig and repeat
• Step 14: Insert roller bearings into top
• Step 15: Prepare friction pads
• Step 16: Place friction pads on base
• Step 17 (OPTIONAL): Remove a bit of shine from the ball
• Step 18 (OPTIONAL): Rub the ball with toothpaste
• Step 19: Insert the ball
• Step 20: Verify that the Ploopy Nano Trackball is working correctly
• Step 21: Spin the ball to break in the bearings
• Step 22: All done!