Ucap faqs

mdandy edited this page Jul 13, 2012 · 2 revisions
  1. How do I set up uCap on my BISmark router?

    In order to run uCap, your must have the latest Quirm firmware installed on your BISmark router. Please refer to BISmark documentation on how to install or upgrade Quirm firmware.

    You can enable uCap on your BISmark router by following these steps:

    • Go to Project BISmark Dashboard
    • Click Configure Your Router
    • Login using your router admin credential
    • Under uCap experiment, check Participate in this experiment. You may want to review the privacy statement before.
    • Click Save

    enable_ucap

  2. How do I manage my whitelist?

    uCap monitors traffic from sites listed in the whitelist. This data is used to calculate your Top Domains Visited that can be found under History & Status. You can manage your whitelist by following these steps:

    • Go to Project BISmark Dashboard
    • Click Configure Your Router
    • Login using your router admin credential
    • Go to BISmark > Passive Measurements. Note: you have to enable uCap first in order to see this option
    • Click on remove button bismark_remove_img in order to remove a site from the whitelist
    • Click on add button bismark_add_img in order to add a site to the whitelist
    • Click Save