You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a Crossguardsaber wired up and everything except the side blades is functioning properly. I just want to make sure I understand the wiring. I currently have the side blades neopixel data lines connected together with a 330ohm resistor going to A0 on the nano, is this correct? I also have the main blade data line connected to D13 with a 330ohm resistor and that one is functional. I might be misunderstanding the pixel accent data.
I also made sure to define it as a crossguardsaber, and put the main length at 120 and crossguard at 12
Sorry to ask, but I couldn't find an answer in the forums, issues or wiki.
The text was updated successfully, but these errors were encountered:
So far you did all right, except for one thing: the sideblades form one stripe with the main blade. Therefore the side blades are connected first to D13, and the output of one side blade to the input data line of the main blade. A0 us not needed
Hello,
I have a Crossguardsaber wired up and everything except the side blades is functioning properly. I just want to make sure I understand the wiring. I currently have the side blades neopixel data lines connected together with a 330ohm resistor going to A0 on the nano, is this correct? I also have the main blade data line connected to D13 with a 330ohm resistor and that one is functional. I might be misunderstanding the pixel accent data.
I also made sure to define it as a crossguardsaber, and put the main length at 120 and crossguard at 12
Sorry to ask, but I couldn't find an answer in the forums, issues or wiki.
The text was updated successfully, but these errors were encountered: