Permalink
Cannot retrieve contributors at this time
Fetching contributors…
Cannot retrieve contributors at this time
| # | |
| # s390 dump config | |
| # | |
| # Configures the actions which should be performed after a kernel panic. | |
| # | |
| # The following actions are supported: | |
| # | |
| # * stop: Stop Linux (default) | |
| # * dump: Dump Linux | |
| # * vmcmd: Issue z/VM CP commands | |
| # * reipl: Re-IPL Linux using setting under /sys/firmware/reipl | |
| # * dump_reipl: First dump Linux, then re-IPL Linux using setting under | |
| # /sys/firmware/reipl | |
| # | |
| # For the actions "reipl" and "dump_reipl" the DELAY_MINUTES keyword may | |
| # be used to delay the activation of dumpconf. | |
| # Thus potential reipl loops caused by kernel panics | |
| # which persistently occur early in the boot process can be prevented. | |
| # Dump on ccw device (DASD) and re-IPL after dump is complete. | |
| # The re-IPL device, as specified under "/sys/firmware/reipl", is used. | |
| # The activation of dumpconf is delayed by 5 minutes. | |
| # | |
| # ON_PANIC=dump_reipl | |
| # DUMP_TYPE=ccw | |
| # DEVICE=0.0.4e13 | |
| # DELAY_MINUTES=5 | |
| # | |
| # Dump on fcp device (SCSI Disk) | |
| # | |
| # ON_PANIC=dump | |
| # DUMP_TYPE=fcp | |
| # DEVICE=0.0.4711 | |
| # WWPN=0x5005076303004711 | |
| # LUN=0x4711000000000000 | |
| # BOOTPROG=0 | |
| # BR_LBA=0 | |
| # | |
| # Use VMDUMP | |
| # | |
| # ON_PANIC=vmcmd | |
| # VMCMD_1="MESSAGE * Starting VMDUMP" | |
| # VMCMD_2="VMDUMP" | |
| # VMCMD_3="IPL 4711" | |
| # | |
| # Stop after panic (default) | |
| # | |
| # ON_PANIC=stop | |
| # | |
| # Re-IPL on panic | |
| # The re-IPL device, as specified under "/sys/firmware/reipl", is used. | |
| # Since the DELAY_MINUTES keyword is omitted, there is no delay and | |
| # dumpconf becomes active immediately during system startup. | |
| # | |
| # ON_PANIC=reipl |