name of the autoloaded rasters and raster calculator

[qgib]

Author Name: Paolo Cavallini (@pcav)
Original Redmine Issue: 3815
Affected QGIS version: master
Redmine category:rasters

---

When running an analysis (e.g. slope) and selecting "Add to canvas", the layer is automatically added at the end of the analysis. The name shown in the legend, however, is not the filename, but the name of the analysis. Problems arise when starting raster calculator:

• different runs of the same analysis (as it happens frequently e.g. with interpolation) cannot be distinguished
• if the analysis, or its translation, has parentheses (this happens at least in IT), the calculator goes mad.

Better to load rasters with their filename.

[qgib]

Author Name: Giovanni Manghi (@gioman)

---

• fixed_version_id was changed from Version 1.7.0 to Version 1.7.4

[qgib]

Author Name: Jürgen Fischer (@jef-n)

---

• crashes_corrupts_data was configured as 0
• assigned_to_id removed nobody
• pull_request_patch_supplied was configured as 0
• version was configured as master

[qgib]

Author Name: Paolo Cavallini (@pcav)

---

• fixed_version_id was changed from Version 1.7.4 to Version 1.8.0

[qgib]

Author Name: Paolo Cavallini (@pcav)

---

• fixed_version_id was changed from Version 1.8.0 to Version 2.0.0

[qgib]

Author Name: Jürgen Fischer (@jef-n)

---

• fixed_version_id was changed from Version 2.0.0 to Future Release - Lower Priority

[qgib]

Author Name: Médéric RIBREUX (Médéric RIBREUX)

---

Hello, bug triage...

in raster calculator and in GdalTools, we need to set a file name to produce the resulting raster. When autoloaded, the name of the file is always used.

I am closing this bug...

---

• resolution was changed from to fixed/implemented
• status_id was changed from Open to Closed
• done_ratio was changed from 0 to 100