diff --git a/documentation/asciidoc/computers/configuration/raspi-config.adoc b/documentation/asciidoc/computers/configuration/raspi-config.adoc
index cb2fa00d7..79056300d 100644
--- a/documentation/asciidoc/computers/configuration/raspi-config.adoc
+++ b/documentation/asciidoc/computers/configuration/raspi-config.adoc
@@ -90,7 +90,7 @@ Enable/disable 2x2 pixel mapping.
 
 ===== Composite Video
 
-On the Raspberry Pi4, enable composite video. On models prior to the Raspberry Pi4, composite video is enabled by default so this option is not displayed.
+On the Raspberry Pi 4, enable composite video. On models prior to the Raspberry Pi 4, composite video is enabled by default so this option is not displayed.
 
 ===== Screen Blanking
 
@@ -232,11 +232,11 @@ Configure the network's proxy settings.
 
 ===== Boot Order
 
-On the Raspberry Pi4, you can specify whether to boot from USB or network if the SD card isn't inserted. See xref:raspberry-pi.adoc#raspberry-pi-4-bootloader-configuration[this page] for more information.
+On the Raspberry Pi 4, you can specify whether to boot from USB or network if the SD card isn't inserted. See xref:raspberry-pi.adoc#raspberry-pi-4-bootloader-configuration[this page] for more information.
 
 ===== Bootloader Version
 
-On the Raspberry Pi4, you can tell the system to use the very latest boot ROM software, or default to the factory default if the latest version causes problems.
+On the Raspberry Pi 4, you can tell the system to use the very latest boot ROM software, or revert to the factory default if the latest version causes problems.
 
 [[update]]
 ==== Update
diff --git a/documentation/asciidoc/computers/raspberry-pi/bootflow-legacy.adoc b/documentation/asciidoc/computers/raspberry-pi/bootflow-legacy.adoc
index 97257b048..56b330110 100644
--- a/documentation/asciidoc/computers/raspberry-pi/bootflow-legacy.adoc
+++ b/documentation/asciidoc/computers/raspberry-pi/bootflow-legacy.adoc
@@ -1,6 +1,6 @@
 == Boot sequence
 
-IMPORTANT: The following boot sequence applies to the BCM2837 and BCM2837B0 based models of Raspberry Pi only. On models prior to this, the Raspberry Pi will try SD card boot, followed by xref:raspberry-pi.adoc#usb-device-boot-mode[USB device mode boot]. For the Raspberry Pi4 boot sequence please see the xref:raspberry-pi.adoc#raspberry-pi-4-boot-flow[Raspberry Pi 4 boot flow] section.
+IMPORTANT: The following boot sequence applies to the BCM2837 and BCM2837B0 based models of Raspberry Pi only. On models prior to this, the Raspberry Pi will try SD card boot, followed by xref:raspberry-pi.adoc#usb-device-boot-mode[USB device mode boot]. For the Raspberry Pi 4 boot sequence please see the xref:raspberry-pi.adoc#raspberry-pi-4-boot-flow[Raspberry Pi 4 boot flow] section.
 
 USB boot defaults on the Raspberry Pi 3 will depend on which version is being used. See this xref:raspberry-pi.adoc#usb-mass-storage-boot[page] for information on enabling USB boot modes when not enabled by default.