diff --git a/documentation/asciidoc/computers/compute-module/cm-emmc-flashing.adoc b/documentation/asciidoc/computers/compute-module/cm-emmc-flashing.adoc
index e57adb39d..29490addf 100644
--- a/documentation/asciidoc/computers/compute-module/cm-emmc-flashing.adoc
+++ b/documentation/asciidoc/computers/compute-module/cm-emmc-flashing.adoc
@@ -13,10 +13,12 @@ The Compute Module has an on-board eMMC device connected to the primary SD card
 
 To flash the Compute Module eMMC, you need the following:
 
-* Another computer, referred to in this guide as the *host device*. You can use Linux (we recommend Raspberry Pi OS or Ubuntu), Windows, or macOS.
+* Another computer, referred to in this guide as the *host device*. You can use Linux (we recommend Raspberry Pi OS or Ubuntu), Windows 11, or macOS.
 * The Compute Module IO Board xref:compute-module.adoc#io-board-compatibility[that corresponds to your Compute Module model].
 * A micro USB cable, or a USB-C cable for Compute Module models since CM5IO.
 
+TIP: In some cases, USB hubs can prevent the host device from recognising the Compute Module. If your host device does not recognise the Compute Module, try connecting the Compute Module directly to the host device. For more diagnostic tips, see https://github.com/raspberrypi/usbboot?tab=readme-ov-file#troubleshooting[the usbboot troubleshooting guide].
+
 === Set up the IO Board
 
 To begin, physically set up your IO Board. This includes connecting the Compute Module and host device to the IO Board.
@@ -52,6 +54,8 @@ To set up the Compute Module IO Board:
 
 Next, let's set up software on the host device.
 
+TIP: For a host device, we recommend a Raspberry Pi 4 or newer running 64-bit Raspberry Pi OS.
+
 [tabs%sync]
 ======
 Linux::
@@ -89,10 +93,11 @@ $ sudo ./rpiboot
 
 Windows::
 +
-To set up software on a Windows host device:
+To set up software on a Windows 11 host device:
 +
 . Download the https://github.com/raspberrypi/usbboot/raw/master/win32/rpiboot_setup.exe[Windows installer] or https://github.com/raspberrypi/usbboot[build `rpiboot` from source].
-. Double-click on the installer to run it. This installs the drivers and boot tool.
+. Double-click on the installer to run it. This installs the drivers and boot tool. Do not close any driver installation windows which appear during the installation process.
+. Reboot
 . Connect the IO Board to power. Windows should discover the hardware and configure the required drivers.
 . On CM4 and later devices, select **Raspberry Pi - Mass Storage Gadget - 64-bit** from the start menu. After a few seconds, the Compute Module eMMC or NVMe will appear as USB mass storage devices. This also provides a debug console as a serial port gadget.
 . On CM3 and older devices, select **rpiboot**. Double-click on `RPiBoot.exe` to run it. After a few seconds, the Compute Module eMMC should appear as a USB mass storage device.