diff --git a/documentation/asciidoc/microcontrollers/debug-probe/getting-started.adoc b/documentation/asciidoc/microcontrollers/debug-probe/getting-started.adoc
index 54fcb5d34..aec938471 100644
--- a/documentation/asciidoc/microcontrollers/debug-probe/getting-started.adoc
+++ b/documentation/asciidoc/microcontrollers/debug-probe/getting-started.adoc
@@ -14,7 +14,7 @@ Connect the following:
 ** Debug Probe `TX` connected to Pico H `RX` pin
 ** Debug Probe `GND` connected to Pico H `GND` pin
 
-NOTE: If you have a non-H Pico or Pico W (without a JST-SH connector) you can still connect it to a Debug Probe. Solder a male connector to the `SWCLK`, `GND`, and `SWDIO` header pins on the board. Using the alternate 3-pin JST-SH connector to 0.1-inch header (female) cable included with the Debug Probe, connect to the Debug Probe "D" port. Connect `SWCLK`, `GND`, and `SWDIO` on the Pico or Pico W to the `SC`, `GND`, and `SD` pins on the Debug Probe, respectively.
+NOTE: If you have a non-H Pico or Pico W (without a JST-SH connector) you can still connect it to a Debug Probe. Solder a male connector to the `SWCLK`, `GND`, and `SWDIO` header pins on the board. Using the alternate 3-pin JST-SH connector to 0.1-inch header (female) cable included with the Debug Probe, connect to the Debug Probe "D" port. Connect `SWCLK`, `GND`, and `SWDIO` on the Pico or Pico W to the `SC` (orange wire), `GND` (black wire), and `SD` (yellow wire) pins on the Debug Probe, respectively.
 
 image:images/wiring.png[width="70%"]