python code to deal with talking to routers using the brnboot bootloader through a serial port and doing simple tasks like backing up the firmware
… does not produce 0x nor L and the if/else is avoided.
|README||README: Added ARV7506PW11 to tested devices list and a thank you to J…|
This tool can, so far, given a serial port connected to a device with brnboot/amazonboot, dump its flash into a file. Homepage: https://github.com/rvalles/brntool It has been tested with - Arcadyan ARV4518PW http://wiki.openwrt.org/toh/arv4518pw (as distributed by the spanish isp ya.com) - Arcadyan ARV7506PW11 (tested by Jan-Philipp Litza) - SMC SMC7904WBRA (as distributed by the spanish isp ya.com) About brnboot: http://wiki.openwrt.org/doc/techref/bootloader/brnboot Cloning ------- git clone git://github.com/rvalles/asbestos-avr8susb Notes ----- The serial port in these two devices is hidden inside their case. If opened, there's a 5x2 header. Going horizontally from the marked pin, which is 1: 2.RX, 3.TX, 5.GND, 6.+3.3v. UART is at 115200bps. Some devices might have a different pinout, but I have yet to encounter any such hardware. To dump the whole flash of my AR4518PW into some file, I do: ./brntool.py --read=AR4518PW_whole.dump --addr=0xB0000000 --verbose --size=0x400000 And then turn it on. A successful flash block read will output '.' while a botched one (a byte or more gets lost in the serial port) will output '!' and retry. Even so, unless in a hurry, I'd recommend to at least dump twice and compare the dumps, just to be on the safe side. See the "erase flash" menu on the menus brnboot provides through the serial port in order to figure out the flash layout in these devices. I cannot guarantee that none of the devices using brnboot will just start erasing the whole flash by just selecting the option, so act at your own risk. Thanks to Jan-Philipp Litza for patches and confirming ARV7506PW11 works. ------- Roc Vallès. <vallesroc @.aaa@ @gmail.com>