New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

1.2.2-dev STL export placing some parts in the air #2393

lordofhyphens opened this Issue Dec 3, 2014 · 1 comment


None yet
2 participants

lordofhyphens commented Dec 3, 2014

Related to #2390, apparently the plater, when STL export is run, is putting some parts in the air for the STL export. Gcode export and toolpaths seem to be behaving just fine.

From the linked STLs, I did perform a cut to remove the bottom .2mm (and rotated bracket2B.stl to put it flat against the bed). bracket2B-allplate.stl is the exported STL from slic3r.



This comment has been minimized.

Show comment
Hide comment

alexrj Dec 12, 2014


Fixed, thank you.


alexrj commented Dec 12, 2014

Fixed, thank you.

@alexrj alexrj closed this Dec 12, 2014

@alexrj alexrj added the Fixed label Dec 12, 2014

@alexrj alexrj added this to the 1.2.2 milestone Dec 12, 2014

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment