Lightweight Crypto on Risc-V

Paper here

Installation of the dependencies.

Have a look at install.sh

We install compilers and libraries in /opt/riscv and in /opt/verilator

⚠️ Execute the install.sh line by line instead of one go (which would likely fail).

Compiling a scheme

First edit config.mk and config.sh to reflect the correct path of the compilers

1. For Sifive

1. Open 2 terminals.
2. Execute ./configure.py [SCHEME Folder] [compiler] sifive to generate the correct Makefile and dependencies.
3. Compile with make
4. Plug your SiFive board, you should see a /dev/ttyUSB0 and /dev/ttyUSB1 appear.
5. In the second terminal, execute ./watch.sh.
   This will start a screen on ttyUSB1 and log the output into main.log
6. In the first terminal, execute make upload (may need sudo).
   This will upload main.elf to the board, you should see output on the second terminal.
7. To compile for another scheme, execute make clean, this will remove any generated file (including the Makefile)

⚠️ it is possible for your board to not display results, this is a bug due to the latest compilers. We included the binary main-valid.elf to "reset" the board in a working state. To flash it on the board, simply do make reset.

2. For pqriscv-vexriscv (aka. murax)

1. Open 3 terminals.
2. Execute ./configure.py [SCHEME Folder] gcc murax to generate the correct Makefile and dependencies.
3. In terminal 1, Compile with make
4. In terminal 2, run make startsim to boot the simulator
5. In terminal 3, once the you read WAITING FOR TCP JTAG CONNECTION in terminal 2, run make openocd to start openocd.
6. In terminal 1, once you read Info : Listening on port 4444 for telnet connections, run make flash. This will upload the binary to the simulator.
7. In terminal 2, you should see the result of the execution.

This simulator requires compilation with GCC and with -O2 instead of -O3

3. For riscvOVPsim

1. Execute ./configure.py [SCHEME Folder] [compiler] riscvOVPsim
2. Execute make startsim

Compiling and simulating using the bit manipulation extension (B)

1. Clone the "RISC-V Bitmanip (Bit Manipulation) Extension" git clone https://github.com/riscv/riscv-bitmanip.
2. Build and install the tools following the instructions from https://github.com/riscv/riscv-bitmanip/tree/master/tools.
3. Execute ./configure.py [SCHEME Folder] gcc_b spike to generate the correct Makefile and dependencies.
4. Compile with make RISCV_ARCH=rv64gcb in order to build a version using the B extension or make RISCV_ARCH=rv64gc to build a version without the B extension.
5. Execute make startsim RISCV_ARCH=rv64gcb in order to simulate using the the B extension or make startsim RISCV_ARCH=rv64gc to simulate w/o B extension. The corresponding binary (see step 4) should be available.