Skip to content
Arduino library for MH-Z19/MH-Z19B CO2 sensor
C++
Branch: master
Clone or download

README.md

MHZ19

Arduino library for MH-Z19/MH-Z19B CO2 sensors.

MHZ19

This library uses software or hardware serial to communicate with sensor. Using MHZ19 you can get CO2, temperature and accuracy values (see examples).

MHZ19PWM

With this library, you can get CO2 level using a single pin which supports interrupt. MHZ19PWM supports three modes:

MHZ_CONTINUOUS_MODE

In this mode interrupt is always attached, getCO2 method executes without significant delay.

MHZ_DELAYED_MODE

The library attaches interrupt only when getCO2 method is called and detaches it after retrieving a single data package. All code will be delayed up to 2000ms.

MHZ_ASYNC_MODE

In this mode, you can request the data by calling requestData method (at this moment interrupt will be attached) and then check if data are ready without blocking the main loop (isDataReady method). As in the first case getCO2 method executes without significant delay.

TESTED ON

Aduino Nano, Arduino MEGA, ESP8266, ESP32.

CHANGE LOG

1.1.0

Refactored code to support both hardware and software serial in a more elegant way and more importantly, to support ESP32.

1.0.0

Initial version. Contains all changes before introducing versioning.

You can’t perform that action at this time.