Cura Print Acceleration

[Domyarus]

Hi,

After going through the Acceleration Tuning, I assessed my Anycubic Kobra Neo is happy to print at the higher 800mm/s/s without any issues of ghosting or corner corruption.

However, on looking at my options within UltiMaker Cura (and appreciate this may be different to other Cura software), the default Print Acceleration is set at 1000.0 mm/S(2).

I note in your example screenshot provided, it's verifies this four figure input but shows your settings as 3000 for some and 5000 for others, post your comment of looking to set your mm/s/s as 400.

This has left me (and perhaps others?) very confused as to what settings I should be using in Cura, given the potential x10 multiplier and variance in screenshot example provided.

Hope that all makes sense?