Releases: totemmaker/labboard-firmware
Releases · totemmaker/labboard-firmware
2.50
Voltages:
- Display "---" when measurements are invalid or out of range.
- Display "not" when VREG is not available because VIN voltage is below 6V.
- Improved voltage measurement and calibration algorithms.
- Stop at limit values when holding +,- keys to change DAC or VREG.
Serial:
- Added LabBoard Serial control protocol.
- Added background serial mode.
- Added Serial pin swapping to select LabBoard control from PC or Arduino.
- Exiting serial mode requires + or - key to be pressed. Allows to use other keys freely.
- Removed serial wiring check for 2.1, 2.2 boards.
- Changed serial mode TX pin from TXD to SWCLK. This allows to use pulse generator in serial mode. RX is still at DIG2.
Pulse generator:
- In pulse mode DIG2 LED displays output state of TXD.
- Improved number input method in Pulse and AD9833 modes.
- Improve Pulse generator mode user interface. Added Frequency (Hz) and duty cycle settings.
Modes:
- Added AD9833 mode.
Other:
- Change display brightness range from
-7
-8
to0
-15
.
2.00
- Firmware rewrite from scratch
- Support v.2.3 revision board
- Mode switch menu
- Settings menu
- I2C scan mode
- DHT11 monitor mode
- Serial monitor mode
- Counter detect edge select
- Frequency counter up to 23Mhz
- Display brightness select
- Manual ADC & DAC calibration
- Manual boot enter
- Version display
- Factory reset