Permalink
Commits on Feb 24, 2011
  1. new repository created at https://github.com/triffid/Teacup_Firmware

    …, updated README
    committed Feb 24, 2011
Commits on Feb 23, 2011
  1. Move timer macros from config.h.dist and derivates to timer.c.

    This sould confuse users less and neither value is subject to change
    per configuration. Reviewed also by Markus Amsler.
    Traumflug committed Feb 22, 2011
  2. gcode_parse: limit decimal ranges by decfloat_to_int()'s demands.

    Formerly, it was limited by variable bit ranges, which allowed
    more than decfloat_to_int() can swallow.
    Traumflug committed Feb 22, 2011
  3. gcode_parse.c: added comments, which show possible variable overflows.

    Stay tuned, the fix is just around the corner.
    Traumflug committed Feb 23, 2011
  4. dda.h: re-add a check against multiple acceleration types.

    This was previously in config.h(.dist), but better belongs
    to dda.h.
    Traumflug committed Feb 22, 2011
Commits on Feb 21, 2011
  1. more README updates

    committed Feb 21, 2011
  2. update README

    committed Feb 21, 2011
  3. intercom: Transmit/receive from/to temporary packets.

    Fixes that the packet could be changed during transmit. And only values from packets with correct checksum are used.
    amsler committed with Feb 21, 2011
  4. extruder: Set/get bed temperature.

    amsler committed with Feb 21, 2011
  5. extruder: add fan definitions

    amsler committed with Feb 21, 2011
  6. extruder: Half-step on every step signal.

    No idea why only every 4th step signal would actually step, but this generates a lot of noise for nothing.
    amsler committed with Feb 21, 2011
  7. extruder: Check the step pin directly.

    Flag could get out of sync, with undefined results.
    amsler committed with Feb 21, 2011
  8. arduino_168: define AIO6/7

    amsler committed with Feb 21, 2011
  9. home: delay is in micro seconds

    amsler committed with Feb 21, 2011
  10. analog mask calculated automagically

    sw committed with Feb 20, 2011
Commits on Feb 20, 2011
  1. add G161/G162 commands, upgrade home.c to provide negative/positive h…

    …oming calls for G161/G162
    committed Feb 20, 2011
  2. bang-bang heater toggle is wrong way around

    Signed-off-by: Michael Moon <triffid.hunter@gmail.com>
    Architect committed with Feb 20, 2011
Commits on Feb 19, 2011
Commits on Feb 17, 2011
Commits on Feb 15, 2011
  1. M140: S value is a temperature

    amsler committed with Feb 14, 2011