NewMatter MOD-t 3d Printer Files, Firmware, Client Software, etc.
Latest commit cece17a Jul 22, 2016 @tripflex add osx app v1.5.3
Failed to load latest commit information.
Calibration Tests
Cura initial push Dec 10, 2015
Slic3r initial push Dec 10, 2015
.gitignore initial push Dec 10, 2015 Add MOD-t details in Dec 10, 2015 initial push Dec 10, 2015 add 0.5.3 upd8 fw, add reddit link Dec 11, 2015
clearnozzle.gcode initial push Dec 10, 2015

New Matter MOD-t 3d Printer Repo

This repository is a collection of files (firmware, test files, configurations, etc) for the NewMatter MOD-t 3d Printer.

WARNING: I take absolutely no responsibility for anything you do with these files or instructions, play at your own risk!

MOD-t Details

Bed Shape: Rectangular
X Axis: 155.4 mm
Y Axis: 104.6 mm
Z Axis: 130 mm

Nozzle Diameter: 0.4mm
Number of Extruders: 1
Heated Bed: FALSE


Information on setting up/configuring Astroprint (with GCode)

Basic GCode information for setting up the printer (including START and END commands)


The file clearnozzle.gcode is intended to help clear a jammed nozzle on the MOD-t. Just connect your MOD-t to your computer with the USB, launch the MOD-t print tool app and select Settings > Advanced Mode > Print File

The MOD-t will do it's little calibration dance and then the nozzle will start to heat to 230ºC (actually it will try, but because the MOD-t is firmware limited to a max temp of 220ºC, it will never get there) and then the print head will move up. The move is just there to indicate that it's gotten to temp. The extruder will then try to push filament through, which should be enough to clear most jams. Finally the print head will move back down and the MOD-t will go back to idle.



This directory contains any firmware files I have been able to find, if you have any that are not in the repo, please open an issue or get in contact me with so I can add them.

Go to the directory and see the Firmware for documentation


This directory contains configuration files for Slic3r:

Launch Slic3r and select File > Load Config and select the file

I recommend going in to Preferences in Slic3r and choosing Expert Mode.


Information/Configuration files for Cura

Calibration Tests

Settings for the Extrusion multiplier in the Filament Settings tab of Slic3r, example image, and code to print a single wall.

Go to the directory and see the for documentation


How to contribute

If you have a copy of firmware files, update suggestions to configurations, or anything else related to the MOD-t ... please feel free to open a new issue and let me know. I'll be more than happy to update or add anything to this repo.


The majority of the information and files were obtained from ajfoul, make sure to check his repository for any other files or updates he may have added: