Skip to content
Permalink
Branch: master
Find file Copy path
Find file Copy path
Fetching contributors…
Cannot retrieve contributors at this time
86 lines (70 sloc) 2.91 KB

#TVIP Masternode Setup Guide ( For Windows QT Wallet )

Prerequisites

#Steps

1. Prepare Trivechain-qt wallet

2. Get masternode private key

  • Execute command masternode genkey in Debug console
  • Mark down your masternode private key

3. Get masternode address

  • Execute command getaccountaddress mymasternode in Debug console
  • Mark down the masternode address

4. Deposit

  • Send 10,000 TRVC to the masternode address
  • Wait for 6 confirmations
  • Note: Make sure the "Substract fee from amount" is unchecked
  • Note: Send exactly 10,000 TRVC, any other amount is not recognized

5. Get the transaction details

  • Execute command masternode outputs in Debug console
  • You will receive an array of valid transaction pairs of "transaction id" : "sequence"
  • Mark down the transaction id and sequence

6. Edit masternode configuration file

  • From the main menu, select Tools > Open Masternode Configuration File
  • Add a line as shown by the example, replace with your details retrieved from Step 2 & 5
mn1 127.0.0.2:9999 93HaYBVUCYjEMeeH1Y4sBGLALQZE1Yc1K64xiqgX37tGBDQL8Xg 2bcd3c84c84f87eaa86e4e56834c92927a07f9e18718810b92e0d0324456a67c 0

Explanation:

Name Masternode IP Address Port Masternode private key Transaction ID Transaction Sequence
mn1 127.0.0.2 9999 93HaYBVUCYjEMeeH1Y4sBGLALQZE1Yc1K64xiqgX37tGBDQL8Xg 2bcd3c84c84f87eaa86e4e56834c92927a07f9e18718810b92e0d0324456a67c 0
  • Save and close the file

7. Edit Trivechain daemon configuration file

  • From the main menu, select Tools > Open Wallet Configuration File
rpcuser=XXXXXXXXXXXXX  
rpcpassword=XXXXXXXXXXXXXXXXXXXXXXXXXXXX  
rpcallowip=127.0.0.1  
listen=1  
server=1  
daemon=1  
maxconnections=24  
masternode=1  
masternodeprivkey=XXXXXXXXXXXXXXXXXXXXXXX  
externalip=XXX.XXX.XXX.XXX
  • Replace the XXXXX:
    • masternodeprivkey : key from Step 2
    • externalip : Your server public IP
  • Save and close the file

8. Enable the masternode tab

  • From the main menu, select Settings > Options > Wallet
  • Check Show Masternodes Tab, click OK
  • Close Trivechain-qt wallet

9. Start masternode

  • Start Trivechain-qt wallet
  • Go to Masternodes Tab
  • Click Start all
  • Note: The status will be PRE_ENABLED, after few minutes, you will see the status change to ENABLED

That's it!

Congratulations in setting up your first masternode! Feel free to discuss in https://trivechain.com if you need further assistance

You can’t perform that action at this time.