Estimated Current Isn't Reported When Off Since 0.15.0

[AlexKusnezov]

What happened?

Estimated Current Isn't Reported When off Since 0.15.0:

0.14.0:

Brighness limiter was on in both cases
After reverting back to 0.14.0 brightness limiter got disbaled so I had to re-enable it manually

Also on Athom bulbs 0.15.0 doesn't report estimated current at all!

To Reproduce Bug

• update to 0.15.0
• look at "estimated current"

Expected Behavior

Estimated Current should be prperly reported

Install Method

Binary from WLED.me

What version of WLED?

0.15.0

Which microcontroller/board are you seeing the problem on?

ESP32

Relevant log/trace output

No response

Anything else?

No response

Code of Conduct

• I agree to follow this project's Code of Conduct

[blazoncek]

0.15.0 uses new ABL, please update settings and verify again.

[AlexKusnezov]

0.15.0 uses new ABL, please update settings and verify again.

Same
unchecked ABL, reboot, check ABL set mA, reboot, result:
"Not Caclulated" when off

[blazoncek]

That is expected. ABL calculation has been moved into LED output driver to support per output limitations.

[AlexKusnezov]

@blazoncek got it, sadly that way the consuption of the esp itself is lost.

[blazoncek]

ESP current is 120mA constant and irrelevant when LEDs are off as far as calculation goes.

[Riscue]

it's not reported to Home Assistant Integration also, lost my power consumption values after 0.15.0

[AlexKusnezov]

it's not reported to Home Assistant Integration also, lost my power consumption values after 0.15.0

that's right, same here.

[DedeHai]

@blazoncek would it be possible to just report the 0.12A fixed instead of 'not calculated'? Or is there any good reason to break backward compatibility with HA? If this is something that is not possible with the new ABL, then this needs to be reported to HA to implement a fix for the new behaviour IMHO.

[blazoncek]

@DedeHai please cherry-pick blazoncek/WLED@eb748f5 from my repo.