Skip to content
Browse files

Remove calibration

  • Loading branch information...
1 parent 345156a commit e58e2ba17dac3d0cb85d1a2aa9e970a1d96ddb3a @adamdeprince adamdeprince committed Mar 11, 2013
Showing with 1 addition and 21 deletions.
  1. +1 −21 arduino/temperature/temperature.ino
View
22 arduino/temperature/temperature.ino
@@ -19,27 +19,7 @@
* of 9 LEDS connected to digital pins 2-10 inclusive, wired in series
* with a resistor between about 300 and 600 ohms.
*
- * Optional calibration:
- *
- * 1. Power down the sensor
- * 2. Fill a glass half full with crused ice and top it off with
- * water. Allow to sit for 5 minutes.
- * 3. Immerse the temperature probe into the ice wate mixture
- * 4. Jumper ground to digital I/O #11
- * 5. Power on the sensor with battery power only and leave powered on
- * until the LEDs stop flashing. This shouldf require about 5 minutes.
- * 6. When the LEDS stop flashing power off the sensor.
- * 7. Remove the wire to digital I/O #11
- *
- * To erase the calibration data:
- *
- * 1. Power donw the sensor
- * 2. Jumper ground to digital I/O #12
- * 3. Wait until all of the lights are lit
- * 4. Power down the sensor
- * 5. Remove the wire attached to digital I/O #12
- *
- * How to read the temperature.
+ * How temperature recording works
*
* There are four distinct steps that go into turning a sensor value
* into a temperature. First we have to address the non-linearity of

0 comments on commit e58e2ba

Please sign in to comment.
Something went wrong with that request. Please try again.