You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The Tool DB Interface for LinuxCNC seems to be broken (still).
A few months ago I have submitted #2719 but the problem seems to be solved partially.
I have created a custom DB interface and at first thought that it was the underlying issue, however I have done dozen of test configs to make sure that what I was doing was not wrong and I came to the conclusion that the issue is caused by my M6 remapping (most probably). When I remove the M6 remap it seems to work properly.
Test scenarios
The DB interfaces loads normally and LCNC seems to fetch the tools properly:
The
Tool DB Interface
for LinuxCNC seems to be broken (still).A few months ago I have submitted #2719 but the problem seems to be solved partially.
I have created a custom DB interface and at first thought that it was the underlying issue, however I have done dozen of test configs to make sure that what I was doing was not wrong and I came to the conclusion that the issue is caused by my M6 remapping (most probably). When I remove the M6 remap it seems to work properly.
Test scenarios
The DB interfaces loads normally and LCNC seems to fetch the tools properly:
I don't know if the STDOUT is messing things up, but I see the output for
g
command twice.When I issue
Tn M6
or try to run my custom procedure to measure TLO i get error along the lines:When I run
M61 Qn
it seems to work properly and invokes the methods connected tol
andu
.When I run
G10 L1 Pn <Axes>
nothing gets printed in the console.Sample files
Here is a gist with some of my config files.
The text was updated successfully, but these errors were encountered: