Environment sensor

Environment sensor project measuring air temperature and humidity. It is made for on LILIGO TTGO-T-Display (development board with ESP32 chip and TFT display), but it can be modified to run on Arduino, NodeMCU or any other similar device.

Wiring

This project uses BME280 module for the measurements. Wiring the this module to TTGO is following.

BME280 | TTGO
----------------------
Vcc    | 5V pin
Gnd    | G pin (GND)
SDA    | pin 21 (SDA)
SCL    | pin 22 (SCL)

TTGO uses different I2C (SCL and SDA pins) mapping than Arduino. This is reflected in the code (by calling Wire.begin(21, 22); in setup()). When using different development board, keep this in mind and change the mapping accordingly.

Setup

First rename (or copy) config.h.example to config.h and set your WiFi credentials along with the ThingSpeak API key (lines 2, 3 and 6). Then set up your Arduino IDE for TTGO module, install required libraries and upload the code.

Warning: Be sure to keep the config.h in the .gitignore file and not to commit it anywhere to prevent your credentials leakage!

You can change the other constants in your config.h to change the measurement frequency, how often the data should be sent to the server along with settings to display the data on TFT. Be aware that only font supporting the degree (°) I found is the font number 1.

If you did not setup your TTGO yet, follow the instructions below.

Setting up TTGO

You need to do some extra steps to set up your Arduino IDE to work with TTGO module.

Add the following URL to Additional boards manager URLs in Settings

https://dl.espressif.com/dl/package_esp32_index.json
http://arduino.esp8266.com/stable/package_esp8266com_index.json

Install ESP32 board in the Board manager (Tools > Development board > Board manager)

Install library TFT_eSPI (by Bodmer) in Sketch -> Include Library -> Manage Libraries
Install library Button2 (by LennartHennigs). Personally I could not find it in the Manage Libraries window. You can install it manually by downloading this ZIP, then navigating to Sketch -> Include Library -> Add .ZIP Library... and selecting it.

Modify User_Setup_Select.h file in your libraries folder (on Mac in ~/Arduino/Libraries/TFT_eSPI). Comment out the default settings line

#include <User_Setup.h>

and uncomment line

#include <User_Setups/Setup25_TTGO_T_Display.h>

Select the ESP32 development board in Tools > Development board > ESP32 Dev Module
Make sure the correct Port is selected in Tools and upload the program

See it in action

This is how the sensor looks like in action. Feel free to improve the code, add more sensors create a printable 3D model for a case!

hom3r/environment-sensor

ErrorLooks like something went wrong!

About

Resources

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Languages

Error
Looks like something went wrong!

Packages