ParticleOS

ParticleOS is a fully customizable immutable distribution implementing the concepts described in Fitting Everything Together.

The crucial difference that makes ParticleOS unique compared to other immutable distributions is that users build the ParticleOS image themselves and sign it with their own keys instead of installing vendor signed images. This allows configuring the image to your liking by having full control over which distribution is used as the base and which packages are installed into the image.

The ParticleOS image is built using mkosi. To build the image, run mkosi -d <distribution> -f from the ParticleOS repository. Currently both arch and fedora are supported distributions. Implementing support for a new distribution (that's already supported in mkosi) is as simple as writing the necessary config files to install the required packages for that distribution.

To update the system after installation, you clone the ParticleOS repository or your fork of it and run mkosi -ff sysupdate update --reboot which will update the system using systemd-sysupdate and then reboot.

Building systemd from source

Sometimes ParticleOS adopts systemd features as soon as they get merged into systemd without waiting for an official release. As a result it's recommended to build systemd from source when building ParticleOS to make sure all required features are supported:

git clone https://github.com/systemd/systemd
cd systemd
mkosi -t none

Then write the following to mkosi.local.conf in the ParticleOS repository to use the artifacts from the systemd repository built by mkosi in ParticleOS:

[Content]
PackageDirectories=../systemd/build/mkosi.builddir/%d~%r~%a

[Host]
ExtraSearchPaths=../systemd/build/mkosi.builddir/%d~%r~%a

To build a newer systemd, run git pull in the systemd repository followed by mkosi -t none.

Installation

Before installing ParticleOS, make sure that Secure Boot is in setup mode on the target system. The Secure Boot mode can be configured in the UEFI firmware interface of the target system. If there's an existing Linux installation on the target system already, run systemctl reboot --firmware-setup to reboot into the UEFI firmware interface. At the same time, make sure the UEFI firmware interface is password protected so an attacker cannot just disable Secure Boot again.

To install ParticleOS with a USB drive, first build the image on an existing Linux system as described above. Then, burn it to the USB drive with mkosi burn /dev/<usb>. Once burned to the USB drive, plug the USB drive into the system onto which you'd like to install ParticleOS and boot into the USB drive via the firmware. Then, boot into the "Installer" UKI profile. When you end up in the root shell, run systemd-repart --dry-run=no --empty=force /dev/<drive> to install ParticleOS to the system's drive. Finally, reboot into the target drive (not the USB) and the regular profile (not the installer one) to complete the installation.

Configuring systemd-homed after installation

After installing ParticleOS and logging into your systemd-homed managed user, run the following to configure systemd-homed for the best experience:

homectl update \
    --auto-resize-mode=off \
    --disk-size=max \
    --luks-discard=on \
    --extra-luks-mount-options "user_subvol_rm_allowed,compress=zstd:1"

Disabling the auto resize mode avoids slow system boot and shutdown. Enabling LUKS discard makes sure the home directory doesn't become inaccessible because systemd-homed is unable to resize the home directory. The extra LUKS mount options are BTRFS mount options to make image builds with mkosi faster by compressing data on disk and allowing users to delete subvolumes.

License

Vasu77df/particleos

ErrorLooks like something went wrong!

About

Resources

License

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Languages

Error
Looks like something went wrong!

Packages