Waveshare ESP32 P4

[ITstreet1]

I just noticed that Waveshare made a few P4 boards that look promising.

https://www.waveshare.com/esp32-p4-nano.htm?sku=29026

https://www.waveshare.com/esp32-p4-module-dev-kit.htm?sku=30560

I wonder if this could be programmed by just selecting the ESP32-P4 board?

[me-no-dev]

If they used the same pins for the C6 WiFi module, then yes. Custom pin selection will come in 3.3.0

[cniedzi]

Hi,

I ordered Waveshare ESP32-P4-Module-DEV-KIT in which ESP32-P4 extends its WIFI functionality by connecting to an ESP32-C6 module via SDIO (ESP32-C6 acts as a slave for ESP32-P4 as host).

Could you please advise (or share a piece of Arduino IDE code) how to program this combo to connect to and use WiFi?

For VSCode they say to add two components to make things done (https://www.waveshare.com/wiki/ESP32-P4-Module-DEV-KIT-StartPage#WIFI_Networking_Demo):

// In a WIFI project, add the following two components through the ESP-IDF component management tool
idf.py add-dependency "espressif/esp_wifi_remote"
idf.py add-dependency "espressif/esp_hosted"

PS. I am on ver. 3.3.0-Alpha1

[me-no-dev]

Not easy. Needs custom board definition to specify the pins used for the C6. You can have a look at the one for our P4 board

[cniedzi]

Not easy. Needs custom board definition to specify the pins used for the C6. You can have a look at the one for our P4 board

Do you mean this definition in ...\Arduino15\packages\esp32\hardware\esp32\3.3.0-alpha1\variants\esp32p4\pins_arduino.h ?

//WIFI - ESP32C6
#define BOARD_HAS_SDIO_ESP_HOSTED
#define BOARD_SDIO_ESP_HOSTED_CLK   18
#define BOARD_SDIO_ESP_HOSTED_CMD   19
#define BOARD_SDIO_ESP_HOSTED_D0    14
#define BOARD_SDIO_ESP_HOSTED_D1    15
#define BOARD_SDIO_ESP_HOSTED_D2    16
#define BOARD_SDIO_ESP_HOSTED_D3    17
#define BOARD_SDIO_ESP_HOSTED_RESET 54

No additional libraries are needed?

[me-no-dev]

yes, but keep in mind this will be overwritten next time you install new core

[Jason2866]

The waveshare p4 nano board uses the same GPIOs to connect the C6 as the espressif p4 eval board. So the p4 nano board will work with the Arduino examples without any changes.