Mingda Magician Max When pressing the stop button Error #5157
Replies: 2 comments
-
How did you create the profile? Did you use ender v3 or any other profile as a base which you then modified? |
Beta Was this translation helpful? Give feedback.
-
Thank you for your help. Since the printer is not selectable, I used the "Generic Marlin Printer" option during setup. Then I had to adjust the speeds and acceleration as they were set far too high. The printer can't cope with that. Apart from a few exceptions, printing works fine. But on the one hand the error when canceling the print and the erroneous prints that still occur out of nowhere. I haven't found a solution yet. At the moment I have integrated Octoprint and entered a stop G-code. But not directly on the printer display. Here are a few prints with Orca Slicer. Sometimes ok and sometimes faulty. |
Beta Was this translation helpful? Give feedback.
-
Hello,
maybe someone can help me.
I have been working with Cura and now want to test Orca Slicer.
The printer is a Mingda Magician Max (Marlin firmware)
There is no suitable profile for it in Orca Slicer.
I have therefore started to create one myself.
I have already been able to make a few test prints.
However, when I press the stop button on the printer (LCD screen) to cancel the test, the printer crashes with the following error message:
Printer stopped Please reset Homing failed.
G Codes files created with Cura do not have this problem.
If the stop button is pressed, the printer aborts and returns to the home position.
I would be grateful for any tips.
Beta Was this translation helpful? Give feedback.
All reactions