- Silkscreen indicates wrong polarity on tantalum capacitors (also in 1.0)
- First batch lacked polarity indicators on some ICs (has been fixed in PCB layout)
- First batch had Q31 reversed. Some boards will ship without Q31.
- TUSB1210 power sequencing requirements conflict with zynq. Lowering the threshold for the 1.8V OK signal is probably a good idea.
- T1 pinout wrong. workaround: cut thermals to pin 4
- D6, D7, D8 connected to wrong node. workaround: leave them out
- T3, T4, T5, T6 drain and source swapped
- Displayport Hotplug signal not connected
- JTAG traces should not go through the connector pads (in case pads get destroyed)
- Holes for through hole components should have larger annular rings
- FT2232D was most likely a bad idea
- R78, R79 serve no purpose, leds pull up more strongly
- Should have a power LED and a power switch
- power connector pinout doesn't match silkscreen
- ETHRESET/ETHINT/USB0RESET/USB1RESET are 1.8V level, but connected to 3.3V output (can be worked around by tristating)
- T2 has wrong footprint. AON7534 happens to fit on this footprint by pure chance. FDMS7676 fits perfectly.
- S1 does not fit footprint
- C194, C195, C196, C197 should be 0603, not 0402