-
Notifications
You must be signed in to change notification settings - Fork 0
Mizar32 bootloader
License
cmp1084/emBLOD
This commit does not belong to any branch on this repository, and may belong to a fork outside of the repository.
Folders and files
Name | Name | Last commit message | Last commit date | |
---|---|---|---|---|
Repository files navigation
================================================================================ ___________ ____________ __________________ ____ \ _ \ \ \ \ \_ \ __ \ \/ \/ 7 _/ / / __ / \_ / 7 / / _ \ /___/ 7 / _ \_ /_ ____/_ /\_/ / 7 / /_ / 7 \ \________/ \__/ /___/________/\______/\_____/___________/ [asmegir.hopto.org] e m B L O D ================================================================================ Content: ========= License Compiling Programming License ========== The License for emBLOD is found in the file COPYING. Introduction =============== emBLOD is a bootloader for AVR32 devices. Bootloading is done from SD(HC) memory card. By default a file named autorun.bin will be booted, but this can be controlled by the boot parameters in the file bootparm.txt. Affected GPIO's ================= The GPIO pins used for USART, SPI etc is set up in emblod_config.h emBLOD toggle GPIO_PB29 during SD card access. GPIO_PB29 is connected to a LED on Mizar32 and EVK1100. Boot parameters ================= If a file named bootparm.txt is present on the SD card root directory the parameters in this file will be read and used during boot. Otherwise the bootloader will try to load autorun.bin with default parameters. If nothing is available to load the bootloader complains and give up. Possible boot parameters: banner - A banner can optinally be displayed. baudrate - The baudrate for the serial port. bootfile - The filename to load bootdelay - If, for some reason, a pause between loading the bootfile and start running the loaded code is wanted, a value in seconds can be given. loadaddr - The bootfile will be loaded to this address. bootaddr - When the bootloader is done, execution continue at this address. fcpu - The frequency of the CPU that the bootloader will turn over to the loaded program. fpba - The frequency of the PBA bus that the bootloader will turn over to the loaded program. Compiling ========== emBLOD will compile by typing: make clean make in the directory containing the Makefile. The default compilation is for Mizar32 Compiling for EVK1100 is done by typing: make clean make BOARD=EVK1100 Programming EVK1100/Mizar32 =========================== Typing: make program will program the binary to the flash memory of the chip.
About
Mizar32 bootloader
Resources
License
Stars
Watchers
Forks
Releases
No releases published
Packages 0
No packages published