Advanced Build & Flash and Flash Onlyy fails

[oliverhbailey]

Linux Distribution

Rasppberry Pi 32 - Debian 11 current release (04/01/2023)

What happened

Using Kiauh, Klipper was rebuilt and flashed after klippy failed to connect when replacing Fluiddpi with Kiauh. Followed instructions on the Kiauh site step-by step and build completed successfully on CR6-SE but was not able to flash using ssh on the host pi. Device was located by UUID for serial upload but when building and flashing, failed to locate the flash program (which was installed after removing the old fluidpi versions of Klipper and Moonraker. When attempting too flash only, the Klipper.bin file could not be located so the flash program was never called.

What did you expect to happen

Build and Flash or Flash Only.

Build and Flash completed build and failed when attempting to flash with an error message the download utility could not be found.. Flash only also failed not being able to locate the ".bin" file. Flash only never reached the point where the download utility was called.

How to reproduce

This was an existing Fluidd installation. Using kiauh, Klipper and Moonraker were removed after the printer database and printer config files were backed up. Then both Klipper and Moonraker were installed afterward copying the printer and database files back to their respective folders under kiauh. Upon reboot klippy failed to connect so klipper rebuild was initiated. Firmware was built without error and put into the klipper/out folder as klipper.bin.

Additional information

I also tried to upload using an SD card in the CR6-SE. It said that Klipper was uploaded and started but there appears to be no way to tell.