You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello,
I'm trying to execute the IQ sample capture on my ANTSDR E310, but unfortunately the side info count is not increasing.
These are the commands I execute:
cd openwifi
./wgd.sh
./monitor_ch.sh sdr0 11
insmod side_ch.ko iq_len_init=8187
./sdrctl dev sdr0 set reg xpu 1 1 // This command is mentioned in iq.md to capture self TX signal, but I'm not quite sure when I should execute it
./side_ch_ctl g
The result I then get is:
loop 64 side info count 0
...
So the side info count remains at 0 and does not increase.
What could be the cause of that?
Best regards,
Emily
The text was updated successfully, but these errors were encountered:
Hello,
I'm trying to execute the IQ sample capture on my ANTSDR E310, but unfortunately the side info count is not increasing.
These are the commands I execute:
The result I then get is:
So the side info count remains at 0 and does not increase.
What could be the cause of that?
Best regards,
Emily
The text was updated successfully, but these errors were encountered: