You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
3D printer brand / version + firmware version (if known)
Prusa MK3S+
Behavior
I had a model with a very small footprint and some supports. I added a large brim (5mm) to give the object greater bed adhesion. When printing, I noticed the the brim printed over and beyond the skirt. This is also visible in preview mode, I just didn't notice it until printing.
The text was updated successfully, but these errors were encountered:
Version
PrusaSlicer 2.3.0-rc2
Operating system type + version
Windows 10 Pro
3D printer brand / version + firmware version (if known)
Prusa MK3S+
Behavior
I had a model with a very small footprint and some supports. I added a large brim (5mm) to give the object greater bed adhesion. When printing, I noticed the the brim printed over and beyond the skirt. This is also visible in preview mode, I just didn't notice it until printing.
The text was updated successfully, but these errors were encountered: