Faders value and banks #288
Replies: 6 comments 11 replies
-
What is bank? |
Beta Was this translation helpful? Give feedback.
-
And what do you mean 'but now'? After some firmware version? |
Beta Was this translation helpful? Give feedback.
-
Good morning Paradajz We have just tested from version 7.5.4, which is the one we started working with. We were wrong, it doesn't work the way we thought it should. The logical operation would be to store the current values in each preset and change the preset, load the memorized values and not send data until the faders, buttons, etc., reach the memorized value. Example. We move fader 1 preset 1 to 50% The logical behavior we believe should be, it does not send anything until it reaches 0%, which is its stored position in this case. Thank you |
Beta Was this translation helpful? Give feedback.
-
This is a very logical and intended behaviour.
Well I do not agree at all, the code works exactly as it should. I don't understand why would you want what you've written. |
Beta Was this translation helpful? Give feedback.
-
I understand the problem: If you control a DAW, the DAW saves the last value and only changes it when the incoming value is greater than the saved value (pickup mode). The controller doesn't need any logic for that. However, if you want to control a hardware synth where the same four potentiometers (potis) are used to control two different envelopes (e.g., preset 1 - EG 1 and preset 2 - EG 2), then the pickup of the values would need to be implemented in the controller. Alternatively, you could buy an Opendeck L and use discrete potentiometers for each value. |
Beta Was this translation helpful? Give feedback.
-
Hi paradajz https://drive.google.com/drive/folders/1cx5g2UEth9GyL1dvsSuufv1R6A4qTauX?usp=sharing |
Beta Was this translation helpful? Give feedback.
-
Hi paradajz,
We have detected an issue with the faders values and banks.
Until now, when you move the fader to a value in bank 1, for example to 25%, and click to another bank 2, and move the fader to 50%, when comeback to the bank 1, the midi output didn't send value until the fader engage to the 25%. But now, when you come to bank 1, the fader sends value immediately.
That's a problem because the midi apps become a bit crazy.
Thanks!!!
Beta Was this translation helpful? Give feedback.
All reactions