Power control

[tbornon]

Hi,

Is it possible to have more informations on the AT+PS command ? How to use it, what are the different modes and the values they can take ?

Regards

[dajtxx]

The only thing I've been able to do is issue at+sleep, and the module sends the response to the command and stops responding, so I assume it has gone to sleep.

Then if I touch the wakeup pin with 3.3v it sends a hash prompt, so it has obviously woken up.

The AT command ref doc says the UART will wake it up, but that doesn't work.

It seems to lose the join state and network parameters, so you have to join again. I tried using the command at+wdct before sleeping to save the MAC state but it didn't help. I can't see a command that loads the MAC state, wdct seems to only write or reset the nvm to default values.