Skip to content

Latest commit

 

History

History
38 lines (24 loc) · 1.3 KB

N-Message.md

File metadata and controls

38 lines (24 loc) · 1.3 KB
Raw

The n Command

The n command sets th Cube into pairing mode. There are 2 ways to invoke this command

Send n: to the Cube, starts pairing mode without timeout. e.g

n:\r\n

Send n: to the Cube, starts pairing mode with timeout (in seconds in HEX) e.g with timeout of 60 sec (60 sec = 0003c in HEX)

n:003c\r\n

Important:

  1. you can stop pairing mode whith an 'x:' command
  2. Before reading the response message wait until the chosen timeout has appeared or you have stopped pairing mode whith an 'x:' command. If you don't do, it is possible that your response messages does not fit anymore to the corresponding commands because of an timeout while reading a response...

The N Message

The N message provides information about newly paired MAX! devices. This response is given after pairing started with the n: command.

N:Aw4VzExFUTAwMTUzNDD/

The N Message is a base64 decoded string. After decoding:

00000000 03 0e 15 cc 4c 45 51 30 30 31 35 33 34 30 ff |....LEQ0015340.|

  Description     Length      Example Value
=====================================================================
DeviceType         1          03 = wallthermostat
RF address         3          0e15cc
Serial             10         LEQ0015340
unknown            1          ff