Mechanical Diagram ----------------
Schematic diagram of main mechanical componentsFlow Actuators <hardware.actuators> Sensors <hardware.sensors> Safety Components <hardware.safety> Tubing and adapters <hardware.tubing>
- Actuator PCB/overview (link to PCB with BoM, schematic, layout, etc.)
- Proportional solenoid valve (V1) (link to doc with crit specs, driving circuit, part spec, datasheet, alternatives, etc.)
- Expiratory valve (V2) (link to doc with crit specs, driving circuit, part spec, datasheet, etc.)
- Sensor PCB/overview (link to PCB with BoM, schematic, layout, etc.)
- Oxygen sensor (O2S) (link to doc with crit specs, interface circuit, part spec, datasheet, alternatives, etc.)
- Proximal pressure sensor (PS1)
- Expiratory pressure sensor (PS2)
- Expiratory flow sensor (FS1)
- 50 psi, high pressure relief valve (PRV1)
- Safety check valve (CV)
- 70 cmH2O patient-side pressure relief valve (PRV2)
- Filters (F1, F2)
- PEEP valve (PEEP) (include the design bifurcation in this module description)
- Manifold 1
- Manifold 2
- Mounting Bracket 1... etc.
Bill of Materials (need to think about what goes in this table, probably separate BoMs into tables by category, but here's a sample table) -------------------
Ref | Name | Part | Description |
---|---|---|---|
V1 | Inspiratory on/off valve | red hat process valve | completely cut off flow if required |
PRV1 | High pressure relief valve | Sets to 50 psi | regulates upstream pressure to 50 psi |
CV | Inspiratory check valve | valve stat here | In case of emergency power loss, allows patient to continue taking breaths from air |
PRV2 | Maximum pressure valve | ... | Sets absolute maximum pressure at patient side to 53 cm H2O |
F1/F2 | Filters | HEPA filters? | Keeps the system's sensors from becoming contaminated |
O2S | Oxygen sensor | Sensiron ... | Checks FiO2 level |
PS1/PS2 | Pressure sensors | mini4v | Uses gas takeoffs to measure pressure at each desired point |
FS1 | Flow sensor | Sensiron flow sensor | Measures expiratory flow to calculate tidal volume |
M1/M2 | Manifolds | 3D printed parts | Hubs to connect multiple components in one place |
V3 | Expiratory on/off valve | Festo Electrical Air Directional Control Valve, 3/2 flow, Normally Closed, 8 mm Push-to-Connect | Opens to initiation the expiratory cycle |
PEEP | PEEP backpressure valve | PEEP valve | Sets PEEP on expiratory cycle! |