| Instruction | |
|---|---|
| Insert M3 Heatset Inserts into the Carriage as indicated. For best results, insert almost completely with a soldering iron before finishing by pressing against a flat, heat resistant surface. |  |
| Insert M3 Heatset Inserts into the Hotend Mount as indicated. Judicious use of the tip mentioned in the previous step will be helpful. |  |
| Insert M2 Heatset Inserts into the Hotend Mount as indicated. For the upper Heatset Inserts, you may use the table method if you're careful not to deform the plastic. For the lower Heatset Inserts, this is less recommended. You may use one of the M2x20s to ream the holes in Xol's boots as the displaced plastic may now act as an obstruction in a later step. |  |
| Insert M2 Heatset Inserts into the faceplate as indicated. Note: The upper Heatset Inserts here are not flat against the plastic part. Attempting to use the flat surface tip mentioned in previous steps will ruin your day. Do your best to make the upper Heatset Inserts parallel to the lower. |  |
| Prepare the wiring for the Z probe of your choice. Follow instructions for your specific selection as provided in that solution's repo. The Heatset Insert tip may or may not be helpful during this step. | This image space left intentionally blank. |
| Attach your hotend of choice (Rapido shown here) using the corresponding screws for your selection. For Rapido, ensure that your heater and thermistor wiring exit toward the rear left. There is no application for the aforementioned Heatset Insert tip during this step. |  |
| Attach the Hotend Mount to the Carriage as indicated, using M3X20 screws in the upper positions and M3x8 in the lower. Note: Don't crush your wiring. |  |
| Fasten the Faceplate and 2510 Hotend Fan to the Hotend Mount with M2.5x20 screws as indicated. For XG, there will only be 2. Ensure that the Hotend Fan wiring exits toward the left as indicated. |  |
| Fasten the 4010 Parts Cooling Fans to the Hotend Mount as indicated using M2x8 in the rear and M2x12 in the front. |  |
| Fasten the 4010 Parts Cooling Fans and attach Ducts as indicated using M2x20 in the rear and M2x12 in the front. |  |
| Attach your selected Extruder with corresponding PTFE. | This image space left intentionally blank. |
| Secure your wiring with zipties. | This image space left intentionally blank. |
| You're done! Congratulations! |  |