You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When Angle of Slope Slice is enabled,
the extruder rises up after each layer.
I have tried all the available versions of CrealityPrint.
After much adjustment I got an acceptable result, but it’s like a hack.
-enable retract when changing layers
-turn on the z rise during retract
and most importantly, I set the lifting height = 0.00
It can be seen that sometimes the z axis rises.
When retraction wipe is enabled, long movements to the origin.
The text was updated successfully, but these errors were encountered:
When Angle of Slope Slice is enabled,
the extruder rises up after each layer.
I have tried all the available versions of CrealityPrint.
After much adjustment I got an acceptable result, but it’s like a hack.
-enable retract when changing layers
-turn on the z rise during retract
and most importantly, I set the lifting height = 0.00
It can be seen that sometimes the z axis rises.
When retraction wipe is enabled, long movements to the origin.
The text was updated successfully, but these errors were encountered: